Search

GoSLAM's UAV mounting kit attaches a compatible scanner underneath a drone airframe such as the DJI M350 for aerial LiDAR mapping.

A compact green cross-line laser level with a rugged grey/yellow housing, magnetic base with rotating knobs, and a rechargeable Li-ion pack, designed ..

This is the complete KLS-515G line laser kit: 4V1H, green beam, 30mW, supplied with a Li-ion battery pack, charger, and hard case.

For use with REED tachometers.

Genuine REED replacement cone-tip contact adapter for the R7100 tachometer. It attaches to the tachometer's shaft to enable direct-contact RPM reading..

Genuine REED replacement large-diameter cone adapter for the R7100 tachometer. Designed for taking direct-contact RPM measurements on larger shafts an..

This is the factory replacement microphone-and-clip assembly for the REED R8085 noise dosimeter, built around the same 0.5 in (12.7mm) electret conden..

The RDC20 is Runione's rugged handheld GPS unit, a compact IP68-rated device with a small colour screen and physical keypad, aimed at outdoor position..

The RDC60 is a 6-inch Android rugged GIS handheld with an integrated multi-constellation GNSS module and 8000mAh removable battery.

The RDC60-Lite is the entry tier of the RDC60 family of rugged Android data collectors, a phone-form handheld with an external GNSS antenna module on ..

The RDC80 is an 8-inch outdoor-visible rugged Android GIS tablet with centimetre-level GNSS positioning via its top-mounted antenna.

The RDC80 Pro is the higher-spec version of the RDC80 tablet, with a 1408-channel GNSS engine for millimetre-level RTK accuracy.

The RDC80-Lite is the entry tier of the larger RDC80 tablet-style controller family, sharing the same 8-inch rugged tablet body.

The RS Base is Runione's dedicated base-station receiver, built in a wider, flatter housing than the rover units to house its high-power 5W UHF radio ..

The RS50 is Runione's mid-tier smart RTK receiver, pairing high-precision GNSS with a built-in green laser and dual-camera AR stakeout system, disting..

The RS50 Lite base-station configuration shares the same puck-style receiver body as the rover unit, differing only in firmware role.

The SinoGNSS E300 is a quadcopter mapping drone built around ComNav's K8 RTK/PPK GNSS module, giving centimeter-level photo positioning without ground..

The SinoGNSS E300 with the C50 camera option uses the same RTK/PPK-equipped mapping airframe as the base E300, but is fitted with ComNav's higher-spec..

This mount kit lets the SinoGNSS LS300 3D laser scanner pair with a DJI Matrice 300 drone for aerial LiDAR mapping. It's built from aviation-grade alu..